Vibration Analysis and Modelling of a Cantilever Beam on Solid Works

The cantilever beam was modelled is SolidWorks for Finite Element Analysis (FEA). In this case, a beam of rectangular cross-section with dimensions was modelled. The beam was simulated in the frequency analysis. A fixture was set at one end of the beam, which represented a fix end. The mesh was created and frequency simulation was run on the beam. The same beam was simulated again by attaching a cylindrical load at its one end. The response of the simulation was noted and are shown in the results section.

The steps used in the creation of model are explained in the video